Insulation contractor in Burley, ID - attics and crawl spaces done in the right order
Total Burley Spray Foam Insulation is an insulation contractor based in Burley, Idaho. We seal and insulate attics, crawl spaces, walls and basements in drafty, hard-to-heat houses across the city, and we work on commercial buildings too.
Insulation work in Burley, our home city
Burley is our home base, so most of our days start here. The calls tend to sound alike. A room over the garage that never warms up, an upstairs that's hot by afternoon, cold floors over a crawl space, or a power bill that keeps creeping up. We see older houses with a few inches of fill that's been sitting up there for years, newer ones where gaps got missed, and a share of shops and commercial buildings. We do the same work nearby in Rupert and over in Kimberly.
In a lot of Burley houses the old insulation has settled thin, soaked up a roof leak or turned into a home for mice, so the job usually starts with what's already up there before we add anything new.
What we do for Burley homes and buildings
Spray foam insulation
Over a drafty garage room or where ductwork runs through the attic, spray foam insulation seals air while it insulates, so it's worth its higher cost there.
Attic insulation
Most calls here start in the attic, so our attic insulation work begins by measuring what's up there and ends with even coverage right out to the eaves.
Blown-in insulation
Blown-in insulation, loose fill sent up through a hose, is how we top up older Burley attics where the old layer has settled thin.
Home insulation
If the whole house feels drafty, home insulation means I look at the attic, walls and crawl space together and tell you which one to fix first.
Insulation removal
When old insulation in an attic here is soaked or full of droppings, insulation removal comes first, because new material laid over it just keeps the problem.
Crawl space insulation
Cold floors over a crawl space are a common Burley complaint. Our crawl space insulation work starts by sealing gaps along the walls and floor, then insulating.
Wall insulation
Some older houses here have walls with little or nothing inside, and wall insulation can usually be blown in through small holes without opening up the whole wall.
Air sealing services
In drafty Burley houses, air sealing services go after leaks through the whole house, at doors, outlets and floor edges, so the cold has fewer ways in.
Basement insulation
A basement room that stays chilly usually needs its walls and the top edge of the foundation covered, and basement insulation is how we handle that here.
Closed-cell foam insulation
Closed-cell foam insulation, a dense foam that blocks moisture, is our pick for crawl space walls and other spots in Burley houses where dampness is a worry.
Open-cell foam insulation
In vaulted ceilings and bonus rooms here, open-cell foam insulation fills the space and seals air, and it costs less than closed-cell where moisture isn't the worry.
Commercial insulation
Some of our calls come from Burley building owners, and commercial insulation covers shops, offices and metal buildings, with the work planned around your business hours.
Crawl space vapor barrier
Where a crawl space here still has bare dirt, a crawl space vapor barrier goes down over the ground first, so moisture stays out of the insulation above.
Vapor barrier installation
Vapor barrier installation in Burley walls and basements is mostly about which side the sheet goes on, because on the wrong side it traps moisture in the framing.
Attic air sealing
Most attics we open here leak air at the hatch and around pipes, so attic air sealing closes those gaps before any fill goes down.
Retrofit insulation
The Burley houses we work on are mostly lived in and finished, so retrofit insulation means adding to what's there with as little tearing out as the house allows.
Talk to us about your attic
Call (208) 679-8041 or ask for an estimate, and I'll come out, look at what's up there and write it up.
Why Burley homeowners call us
What I watch hardest is the order of the work, so nothing gets buried that should've been fixed first. If a job isn't ready yet, I'll tell you plainly.
The owner at your house
I come out to look and write the estimate myself, and our crew does the work with me running it.
Bad insulation out first
If what's up there is soaked or full of droppings, we pull it out before anything new goes in.
Eave vents kept clear
We keep the vents at the eaves open so the attic can still breathe and moisture stays out of the framing.
Permits checked before we start
We check with the building office for your address, and if a permit is needed we handle it and the inspections.
Licensed, insured and guaranteed
We're fully licensed and insured, and every job carries the same promise, "Your satisfaction, guaranteed."
Insulation questions from Burley homeowners
How do I find out if I need a permit for insulation work in Burley?
Ask the City of Burley's Building Department, which issues building permits inside city limits and asks that you talk with the Chief Building Official before any construction begins. Its permits cover buildings that are built, added to or structurally changed, and insulation isn't spelled out on that list, so it's worth asking rather than assuming. Before we start, we check with the building office that covers your address, and if your job needs a permit we take care of it and set up the inspections.
Who handles permits if I live just outside Burley city limits?
Cassia County's rules cover county land outside Burley city limits, while in the unincorporated Burley Impact Area on the Minidoka County side, an older city code section has the Burley Building Inspector issuing building permits. That line can run close to home, which is why we look up the office for your exact address first, as above.
Does my insulation contractor need Idaho state registration?
Yes, for most jobs, since Idaho Contractors Board guidance says registration applies to any construction job over $2000.00 in materials and labor unless the contractor is exempt. The board's guidance also says a contractor who should be registered but isn't can't get a building permit, and gives up lien rights and the right to sue for pay under that contract. If you're insulating your own house on your own land and don't plan to sell within 12 months, you're exempt yourself.
Does a contractor need a business license to work in Burley, ID?
Yes, Burley city code requires a license from the city administrator or city clerk to run any business inside city limits, and that includes independent contractors. The city's application lists a $25.00 fee for all applications, so it's a fair thing to ask any contractor about before work starts.
How much does attic insulation cost in Burley?
It comes down to the size of the attic, how many inches are already up there, and whether the old insulation has to come out before anything new goes in. Sealing gaps adds labor but usually does more good than extra depth, and foam costs more than loose fill because it seals and insulates at once, so I only push it where ductwork runs through the attic. A tight attic or a hard-to-reach hatch adds time, and your estimate gives you your own number after I've seen the house.
How long does attic insulation take, and when can we go back inside?
Prep sets most of the schedule, so a plain top-up goes faster than a job where old insulation has to come out and gaps get sealed first, and a permit or inspection can add time too. With blown-in loose fill you usually don't need to leave, but spray foam has a re-entry time, the wait before you, the kids and pets come back in, set by the foam maker's instructions. I'll go over the timing for your job at the estimate so you can plan around it.
Not in Burley? Call us anyway
We also work in Rupert, Kimberly and the cities around them. Pick another listed city if you see yours, or call (208) 679-8041 if it isn't listed.
Ask Total Burley Spray Foam Insulation for an estimate
We pick up from 6 AM to 11 PM, seven days a week, so call (208) 679-8041 or send the form whenever it suits you.